The scissor has been designed in such a way that as many railings as possible can be produced by using it. The design limit has been reached at a clear distance of 120mm (4.72 in.) for sloping railings.

There are special booms for larger railings. Please get in touch with us.

A deviation of a maximum of 2 mm is within the manufacturing tolerance of the railing. Given a larger deviation, the CREASTAR has to be cleaned, and the scissor has to be moved apart and together again completely in order to compensate the springs.

After undoing the three adjusting screws of the support rail, the U profile can be turned. Thus the support area turns to large that hand rails up to 42mm (1.65 in.) can be placed without any problems. The standard brass angle can be replaced by an L profile, if even larger support area are required.

No, they aren’t; the scissor is protected by a special heat-resistant plastic cover. Now and then weld spatters may burn in, but that is only an aesthetic problem. The covers can be replaced.

Often enough there is one man missing to turn the element, especially in smaller companies. The gauge can be set so fast that a maximum of time saving is achieved especially in case of individual units. And: Stair railings with variations at a tenth of a degree and small differences in length in particular, the EDP values can be set in a matter of seconds.